The system is almost 100% complete and I have begun testing throughout the cycle. As far as the setup goes I am pretty happy with how it turned out for the most part and how it's running. I still need to get my canopy and wood stand built for the tank. I also need to get the calcium reactor running and I am waiting for a solenoid and some RODI "Y" fittings to come in so I can get my water change making setup complete. Once I have a second solenoid and 2 Y's I would like to set up the rodi to feed my
auto top off tank like it has been using a Buckeye High Low switch with a pressure float switch as a fail safe and at the same time be able to make water controlled by a timer or float switch as well.
Because of my ankle injury and not being able to move much I didn't do any of the plumbing on my manifold or any of the reactors that run on it. It was all done by an old friend who used to be a vendor here. Most old timers remember Leo from NACLH20! Leo did a great job with the plumbing and allot of other things to get the system up to his standards. Most of it is being fed with RO push fittings and valves to make adjustment and maintance very simple. Everything is unioned and easy to remove and swap out of needed and also setup on my controller. Here are the pictures.