so i show up to work today and my boss says here put this new pump on one of our 180 reef tanks, being a fairly experienced reefer said sure no problem. It was a tunze wave box, never working with one of them i figured it couldnt be that hard to figure that out so i said challenge accepted.....well that is where i went wrong, i open the box and other than the fact that there are like 9000 pieces/wires in the box(insert its over 9000 jokes here for the few of you that would get that reference) i think i would prefer an ikea special set of directions compared to this manual, its in like 6 languages and they are not grouped together. still i was slightly optimistic, i plugged the outlet cord into the power supply ballast and the photo cell into the controller NOW HERE IS WHERE I GET CONFUSED: 1. there are two ports to plug the actual pump for the wave box into, which do i use? 2. there are several different sized voltage chips that it says to plug into the bottom, the bottom of what there is no place for them to go? and 3. which i think is the most important of all, there is no place to plug the power supply into the actual pump or the controller!!! being confused i read the directions several times, googled around for at least a half hour even trying to find a video n youtube, asked every and any reef customer that walked into the store (even some of you on here) if they have seen or used a wave box only to get replies of how their tunze ato was a pain in the @$$ to install and then I even called in Jared (lfsmarineguy) for some backup to find out he had never used one before either which shocked me. well what i guess im saying is what in the world could i be missing, and if the previous questions can be answered how do i go about setting it?