Reef Doser programming?

[Paul101]

I am trying to get the second channel of a two channel, Aqua Medic Reef Doser to lag the first channel, (both set the same "cycle" and "on" time,) by three minutes for dosing two part. Do I just wait three minutes to hit the "enter" key on the second channel, or what?

 

[fluidimagery]

yes you do.

Setup the first channel with the appropriate time and interval... the channel should run once it's all the way through

Then wait X amount of time if you want to lag the two channels and setup the second channel the same way.

If you hold down the two right buttons (forget the names) for two or three seconds it'll switch between the channels. Once you setup the second channel you should be good to go


One thing to note.. unless Aqua Medic fixed the issue. If the power goes out the Doser will lose the lag time and will need to be setup again. It'll keep the correct time and interval though.

good luck.

 

[Paul101]

Thanks so much.