thanks Jimmy, i did the reset and still nothing, also just to be clearer , its the updated qd driver to the older es dryside and then to the updated qd wetside which on ecotechs site they say its compatible, im also not getting the flashing green/red light, it tries to turn then goes to the next mode, tries to turn then goes to the next mode etc. going through all the available modes ......sometimes if i put it on low then make them connect slowly it will run and i can even turn it up but ill get about ten minutes until the dryside gets really hot then it'll shut down and ill get the green/red light .....when theyre not connected the driver and dryside run no problem ...... i dunno! i think its time to call ecotech
