- Location
- the dirty Jersey
I have had this for a few years but downgraded, so here goes...
90 gal Oceanic Tech tank, eurobraced, starphire glass on the front. Not sure if it is also on the sides... Has ABSOLUTELY NO Leaks, cracks, chips, etc., but there are a few small scratches on glass. These are hard to see when it is filled (actually hard to see when empty too). Very minor on front panel. A few on the sides near the top, where circ pumps were mounted.
Homemade stand. See pics. This thing is SOLID. It is 23.5" deep, by 54" wide, by 35" tall. A bit taller than most store bought stands which is nice for viewing, and also allows for a taller skimmer. The stand could use a fresh coat of paint. Some of the hardware has a bit of rust from salt...
Oceanic sump. dims are 12.5"deep X 36" wide X 17" tall. Again, no cracks or leaks, but it could use a better cleaning. I did move the dividers inside to suit my needs, so it isn't the original layout.
Plumbing is as shown, but you see a strainer for one downpipe broke off... I epoxyed it back on and if you are careful it will stay, but it's not perfect. Also, see the barb end on one return pipe has a small piece broken off. There may still be enough there to grab with a hose clamp, but I am just putting it out there.
Tunze 1073.04 return pump. Runs great. Nice and clean.
Also an NAC7 skimmer. Works perfectly. Runs dead silent.
Looking for $400 for all.
I will post pics later. I do have pics on reefcentral nj forum. Looking to sell as a package. Will not deliver, but I can help load into your vehicle.
90 gal Oceanic Tech tank, eurobraced, starphire glass on the front. Not sure if it is also on the sides... Has ABSOLUTELY NO Leaks, cracks, chips, etc., but there are a few small scratches on glass. These are hard to see when it is filled (actually hard to see when empty too). Very minor on front panel. A few on the sides near the top, where circ pumps were mounted.
Homemade stand. See pics. This thing is SOLID. It is 23.5" deep, by 54" wide, by 35" tall. A bit taller than most store bought stands which is nice for viewing, and also allows for a taller skimmer. The stand could use a fresh coat of paint. Some of the hardware has a bit of rust from salt...
Oceanic sump. dims are 12.5"deep X 36" wide X 17" tall. Again, no cracks or leaks, but it could use a better cleaning. I did move the dividers inside to suit my needs, so it isn't the original layout.
Plumbing is as shown, but you see a strainer for one downpipe broke off... I epoxyed it back on and if you are careful it will stay, but it's not perfect. Also, see the barb end on one return pipe has a small piece broken off. There may still be enough there to grab with a hose clamp, but I am just putting it out there.
Tunze 1073.04 return pump. Runs great. Nice and clean.
Also an NAC7 skimmer. Works perfectly. Runs dead silent.
Looking for $400 for all.
I will post pics later. I do have pics on reefcentral nj forum. Looking to sell as a package. Will not deliver, but I can help load into your vehicle.
Attachments
Last edited:
