Does anyone have a remedy to get these too stick/stay put on the glass? I wiped the glass area where I'm putting the pumps with vinegar. I let it dry. Put the black rubber circle on to the tank. It wouldn't stick like I see in the videos. I hold it with my hand and place the wet side into the tank to where I beleive it will connect with the dry side, plug it up and the wet side falls to the bottom. Measured the glass thickness on the sides and its 1/2 inch thick. Still didn't work. Tried moving the dial to 5/8 on the dry side and no luck. Any suggestions?
Mp40's won't stick
- Thread starter b-ridge
- Start date
- Location
- bayonne / nj
Try eliminating the black rubber spacer . Also check too see if the dial is correct / they are a pain to read .
- Location
- Long Island
They should hold perfectly. Is the wet side jammed up? Can you spin the impeller with your hand easily? The magnet should be plenty strong enough to hold. Mine are on 3/4" thick starphire and it holds.
- Location
- Amityville, NY
What everyone said...don't use the rubber spacer and double check the pin/spacer alignment is correct.
Sent from my SM-N920P using Tapatalk
Sent from my SM-N920P using Tapatalk
Sponsor Reefs
We're a FREE website, and we exist because of hobbyists like YOU who help us run this community.
Click here to sponsor $10:
